Redneck Engineering Choppers Reps Ride

Redneck Choppers, you probably have heard of them or at least seen one of those choppers at a show.  They’re a brand known for his or her reasonable prices, duct-tape engineering and a whole with a heap of humor! This Chopper is owned by Mike Marquart of South Dakota as Reps Ride and is built using Redneck Engineering’s GettinHigh frame.
The famous or not so Famous GettinHigh Chopper from Redneck Engineering. THis GettinHigh frames are common frames for the past few years currently, they are cheap, sturdy and most importantly they give the impression of being dangerous as hell!

Reps Ride is built on a Standard Gettinhigh Frame with a forty eight degree Rake, eight? up and 5? out stretch. The Front Finish may be a Redneck Mid Duece (not positive if that is miscalculation or intentional) Front finish with ten over. The Handle Bars are Redneck Billy handle bars.
Reps Ride features a Redneck King gas tank, and a custom built Redneck fender on the rear. This is sitting on a Weld Smoothie 18?eight.5 rear wheel with a 250 tire and a CCI/West Coast 2?a pair of.5 front wheel. The wheels have HHI 4 back and front brakes for stopping power.

All of this hardware is powered by a one hundred Revtec motor with a Andrews EV38 Cam and for delivery Mikuni HSR 42 Carb. The power is hooked up to a Revtec half-dozen speed transmission with a BDL three in. primary. The exhaust is a Grumpys One Off.
The Flame and Silver Paint is done by Billy Hudson.

Mike’s Reps Ride is simply a classic trying chopper, it very demonstrates what can be done with the Redneck Engineering Frame. Its High, its long and its overall a nice looker!